ASIO4ALL 中国官方主页

Windows ASIO 驱动程序


如果禁用硬件缓冲,则此控件允许您添加最多两个缓冲区来排队等待音频输出。 每增加一个缓冲区,设备的输出延迟就会增加播放缓冲区所需的时间。

因此,“2”的初始设置只应在功能较弱的机器上更改,并且仅在默认设置无法达到合理小的 ASIO 缓冲区大小时才应更改。

如果启用了硬件缓冲,则此控件确定 ASIO4ALL 将数据插入/读取到硬件缓冲区的位置与 ASIO4ALL 当前考虑硬件读/写位置的位置之间的间隙量(以毫秒为单位)。

  • 入门

    Getting Started

    Setting up your audio software In order to make use of ASIO4ALL, you need to configure your audio software accordingly. How you would do this depends on your particular software application. Generally, you would always enter the audio configuration menu and select ASIO -> ASIO4ALL v2. There now should be a button to launch the… 更多

  • 基本配置

    Basic configuration

    WDM Device List This is the list of audio devices found in your system. Highlight the device that you want to make changes to. Note: All parameter changes always only apply to the device currently highlighted! Activate the device you want to use by clicking on the button next to the device name! In the… 更多

  • 高级配置

    Advanced configuration

    Once the control panel has been switched to advanced mode, things begin to look a little more complicated. The device list is now expandable and you can enable more than one item at a time. Device list items explained: Devices are independent hardware units most of the time. It is easy to understand the concept… 更多